Services - Mega Dry

MEGA DRY SERVICES

INTERIOR DRAIN SYSTEM

An interior drain system effectively captures and redirects water away from your foundation to prevent basement water damage, mold, and structural problems.

FOUNDATION CRACK REPAIR

High-pressure crack injection is a repair technique used to seal cracks in concrete structures, preventing water infiltration and restoring structural integrity.

EXTERIOR WATERPROOFING

An exterior waterproofing membrane is highly effective. After excavating the walls down to the footings, the waterproofing team cleans the wall and applies the membrane. After that, the membrane is covered with a heavy duty drainage/ insulating board. Then the excavated area is filled with A6 grave and backfill dirt/soil.

ROD HOLE LEAKS

A rod hole is a common weak point in a basement wall where water can infiltrate. These holes are left behind from the construction process when steel rods (snap ties) are used to hold concrete foundation forms in place while the walls are poured. After the forms are removed, small holes remain, which can allow water to seep into the basement if not properly sealed.

DOWNSPOUT EXTENSIONS

A downspout extension is an attachment added to the end of a gutter downspout to direct rainwater away from your home’s foundation. Properly extending downspouts helps prevent water damage, basement flooding, and soil erosion.

WALL WRAPPING / INSULATING

The Flex-Foil helps reflect radiant heat energy in the summer and retains heat in the winter, increasing your home’s efficiency and decreasing your energy bills. It also seals out moisture, soil gases, and works as a radon deterrent.

PANEL CRACK

Durawall panels are non permeable moisture and vapor permanently installed to the foundation. Moisture entering the foundation is directed into a subfloor dry well.

CARBON FIBER STRAPS

The Fortress open grid technology combined with the epoxy rivet technology connects to the carbon grid to form a mechanical bond on the wall. The carbon fiber strap system is guaranteed minimum tensile strength of 234,700 psi.

CRAWL SPACE STABILIZATION & LEVELING

Leveling jacks are used to lift and stabilize uneven foundations, restoring the structure to its original level and preventing further damage.

CRAWLSPACE ENCAPSULATION

Crawlspace encapsulation improves indoor air quality, reduces energy costs and protects the home against moisture and pests.

SUMP PUMPS

A sump pump is a crucial tool for protecting your home from water damage, especially if you have a basement or crawl space prone to flooding or moisture buildup.

BATTERY BACK UP SUMP PUMPS

Pitboss Battery Back Up System - Most powerful 12-volt Battery Backup System pumps 2,580 gallons/hour at a 10′ lift. The PitBoss Battery Backup System features a waterproof circuit board for increased reliability near the sump basin. Warnings and alarms signal the homeowner if there is a problem. Controller automatically tests the backup pump weekly. Includes: built-in charger, float switch, backup pump, and battery case.

I-Beams/Power Braces

I-Beams/Power Braces are steel supports shaped like the letter “I” and are commonly used to reinforce walls, floors, and structural framing. They provide extra strength and stability, preventing issues like bowing walls, sagging floors, or structural failure.

Wall Anchors

Wall anchors have been a traditional method for stabilizing bowing basement walls. This system involves placing steel plates on the interior wall and connecting them to anchors buried in the soil outside. The anchors pull the wall back into position, counteracting the external pressure causing the bowing.